Oct 16, 2008 07:13 am Or, with a little extra effort, you don't need to use tape at all. Just pliers and a screwdriver.
Copper wire and clamps for under ten bucks at your hardware store.
rugged and easy x-y setup with k-micros
Posted on Oct 16, 2008 05:09 am
End of Fall
Mikey Spencer
Member Since: Apr 26, 2007
im bored trying to find reasons to procrastinate studying for midterms.....
honestly, this is why the k-micros are pretty cool. small and possible to do things like this and not caring about covering them in duct tape cause they were only 10 bucks.....
[ Back to Top ]
Oct 16, 2008 07:13 am Or, with a little extra effort, you don't need to use tape at all. Just pliers and a screwdriver.
Copper wire and clamps for under ten bucks at your hardware store.
Oct 16, 2008 09:50 pm Herb, you've got to put a small pice of soft rubber or foam in between the mic's and the clips as those copper wires are going to be vibrating and sending that through the mic's.
Oct 16, 2008 10:18 pm I like infrasonics. They add to the ambience.
Oct 17, 2008 07:40 pm Yes they do, good point.
I guess.
Oct 17, 2008 08:01 pm www.mindcontrolforums.com/news/infrasound.htm
Fortunately, the Micros are down a dB or two below 20 Hz.
Oct 17, 2008 09:27 pm I'm guessing you watched the Myth Busters episode on this. When they actually got the big bridge to vibrate a bit with a tiny little unit they constructed and attached to it.
In the end they could only state it was Plausible though.
|
Related Forum Topics: |
If you would like to participate in the forum discussions, feel free to register for your free membership.