question about chains..

> > > question about chains..

Posted on

Contributor Since: Apr 03, 2002

ok suppose you were getting ready to lay down some vocal tracks.. and you have a good mic preamp (hhb radius 40) and a mixer with a built in preamp(behringer 1804x) and a couple other processors in the chain..

whats the correct order on this? and should i remove the other processors should i decide not to use them? the way i see it.. the hhb has to be better than the behringer preamp..

so where can i place it to make sure that i am getting the most out of it?

ps. dont have the hhb just yet.. but i will here in a couple days, so i figured id ask ahead of time to make sure im ready to go when it gets here hehe.

[ Back to Top ]


Administrator
Since: Apr 03, 2002

Apr 04, 2002 05:27 am

uuummmm, what are the "other processors"...that kinda matters...

Contributor
Since: Apr 03, 2002

Apr 04, 2002 01:02 pm

hah somehow i knew i should have included that first time around.. one is a dod votec floor unit.. and the other is a zoom studio 1204.

Czar of Midi
Administrator
Since: Apr 04, 2002

Apr 04, 2002 11:29 pm

Use the HHB straight into the board, just make sure not to crank the board's pre to hard. Remember the gain is highest at the begining of the chain. I would put the other FX into the aux send and return loop, that way you can pop it in and out at will. I would run the 1204 first in the chain and then the votec.

Noize

> > > question about chains..

Related Forum Topics:


If you would like to participate in the forum discussions, feel free to register for your free membership.