Posted on Jun 11, 2011 07:30 pm
MusicallyMrM
Member Since: May 13, 2011
Hope there are some Tascam Users In Here.
Bought a used 788 2 months ago. Didn't have a power supply. Got a new factory supply from Tascam and this 788 looks and works like new. Installed a 40 gig drive in place of the 7.5 that was in it and that's quite adequate for most of the stuff I do with this machine.
The problem that I'm having is that after recording tracks and I go to adjust eq in the mix and I see the change occur on the screen but I can't hear any change. I have no problem setting them eq levels before the recording but after the recording, I can't get them to change. (I actually have a similar problem with the effects too) It's got to be something I'm doing wrong and it seems as though I'm doing what the manual says (although the manual uses some weird conventions for many of it's explanations) Doing most of my playback through the monitor outputs through my Crown Amp. What am I doing wrong?
[ Back to Top ]
Related Forum Topics: |
If you would like to participate in the forum discussions, feel free to register for your free membership.