Tascam us 144 help :(

Posted on

Member Since: Dec 26, 2010

hey guys i'm new to all this kinda stuff, so hello firstly.

basically i just got a tascam us 144mkii and i installed the disc and on the control panel of it says - "no valid signal" even though i have my bass going directly into it? the usb light was on but now it doesn't even seem to do that.

Any help would be much much appreciated :)


[ Back to Top ]

Prince CZAR-ming
Since: Apr 08, 2004

Dec 28, 2010 01:13 pm

Hello Ollie

Not sure if it applies, but my Biostar motherboard has USB chipset that doesn't work with my US122 (older model). It works OK on my laptops, but not my main audio rig.

No big deal for me, as I have a PCI interface for the audio rig.

But, I figured I'd throw that out there.

Otherwise, I had to re-install my drivers a few times on my laptop, as it seemed to forget that I installed the drivers. It's been fine now, not giving me any problem.

Is the gain turned up? that will keep you from getting good signal in the PC. Do you see activity lights on the 144? mine has lights that flash green for signal, red for clipping.

Related Forum Topics:

If you would like to participate in the forum discussions, feel free to register for your free membership.