Posted on Jun 03, 2010 04:24 am
Butch
Member Since: Jun 03, 2010
I have a UA-25 interface that I'm using for voiceover work. It seems the only way I can adjust the volume level in my headphones is by using the"output" pot. This, however, affects the "record" level of the signal being sent to my computer. I assumed the pot labelled "volume Direct Monitor" is used to adjust the headphone volume level; but when I turn it, nothing happens. Is there something I'm missing here, a hardware/software issue? I've been Adjusting the output volume to an audible level and then adjusting the sens level, on the mic input to compensate. Can't figure it out. could be something simple. I'm going nuts!
Thanks.
[ Back to Top ]
Related Forum Topics: |
If you would like to participate in the forum discussions, feel free to register for your free membership.