Posted on Aug 16, 2009 08:31 pm
Custom Jimmy
Member Since: Aug 16, 2009
Hi all, first time caller. I recently had the horns in my PA speakers replaced after one blew. The crossover capacitors were also replaced. I picked them up late and didn't have time to test them before a gig. They sounded brain-slicingly tinny and I had to knock all the high frequencies on the EQ close to zero to stop them squealing like a stuck pig, and everything sounded awful all night. The replacements were rated to a higher wattage than the originals. I have very little knowledge on the subject but have years of experience with PAs (i.e. enough to be 100% the speakers are at fault, not me this time.
Any help or suggestions would be appreciated. Plan B is to replace all bits with the same gear as the old. I'm hoping Plan A might be cheaper. Cheers, Jim.
[ Back to Top ]
Related Forum Topics: |
If you would like to participate in the forum discussions, feel free to register for your free membership.