setting up tascam us1641
Home > Home Recording Forum > Recording Techniques > setting up tascam us1641
Posted on Oct 24, 2008 10:48 pm
kkraft67
Member Since: Oct 24, 2008
Hey having trouble setting up
1641 on mac computer. What I am trying to do is run each mic on individual channels on logic pro, can only seem to get 2 inputs to connect and only on same channel ... am I overlooking something or is this just the way it is ... any help in config is greatly appreciated
thanks
Kelvin
[ Back to Top ]
Dematrixhttp://www.reverbnation.com/2ndgMember
Since: Nov 27, 2007
Oct 24, 2008 11:19 pm check in yer Logic Pro manual under "VST Connections" Or "Connections"
that should tell you everything ya need.
what you need to do is set up those so your software program recognizes that you wanna use the other inputs on your Tascam.
eg, set up a new bus where it says "add buss" and choose the number of the input you wanna use on the Tascam there, which is under device port or something of that nature.
then in your project you need to assign that new buss to the new track when you create it.
