BEHRINGER 2222FX
Home > Home Recording Forum > Recording Techniques > BEHRINGER 2222FX
Posted on Jan 11, 2008 05:15 pm
vee2one
Member Since: Jan 11, 2008
hi i have a behringer 2222fx, i have everything set up.
but cant get it to record in cubase?
my micz pluged in, phantom power is on, sound cards all connected.
its really annoyin as my old mixer worked perfect.
any ideas?
regards
V
[ Back to Top ]
pjkPrince CZAR-mingMember
Since: Apr 08, 2004
Jan 11, 2008 05:27 pm Hey there Vee, welcome to the HRC.
you haven't given very much information, so i'll nutshell my ideas.
mic plugged into mixer
phantom power turned on
Gain turned up, and seeing signal on channel
buttons selected so signal is directed to correct output
Output of mixer connected to computer interface (soundcard of some sort)
In PC, does software see the interface (and inputs)
in software, does meters show signal coming from inputs (that are connected to mixer outputs)
is track armed and ready to receive signal
are you pressing record? (kidding)
It would help to know what interface you're using, and how your old mixer was hooked up. Is it any different now? are you using different interface? etc.
More info the better, I'd say.
Jan 11, 2008 05:35 pm the mic is plugged in, phantomz on.
the mixer only shows its pickin the mic up when i press the clip buttin and still then its only cumin throught the left channel, the panz centred and the gain is up. trimz set to 0. cubase has detected the audio interface. i get sound cuming out but it just wont pick up the microphne, i had a reall small behringer mixer before this and it worked perfectly.
i have my monotor speakers connected and my stereo connected to the main output whcih is at the back of the mixer.
any help please?
thankz for ur reply:D
Noize2uCzar of MidiAdministrator
Since: Apr 04, 2002
Jan 12, 2008 05:44 pm How is the mixer routed to the sound card? Meaning were is the cable coming out of the miser and were is it going into the sound card.
You are obviously only sending one side of the mixer channel to the mains, and whatever else you have connected.
Jan 13, 2008 09:08 am iv sorted it, i needed to route my mixer from the SUB OUTPUT to the INPUT on my USB AUDIO INTERFACE
thnkz for al of your help
V
