Question about Monitors and sound cards
Home > Home Recording Forum > Mixing Techniques > Question about Monitors and sound cards
Posted on Nov 24, 2007 07:22 pm
Mark Dove
Member Since: Nov 24, 2007
I have a M-audio Firewire Solo going into a Alesis R300 power amp with 2 Alesis monitor one monitors. I turn the audio card full blast and the amp full blast and I can barely hear the music from the monitors. What gives? Do I need to run the sound card into a mixer before the amp???
thanks a bunch!
[ Back to Top ]
Noize2uCzar of MidiAdministrator
Since: Apr 04, 2002
Nov 25, 2007 12:23 am Welcome to HRC.
Have you checked the software settings yet? That sounds like what might be the problem. The M-Audio unit should have its own control panel that you can set the output volume with.
Otherwise it could be the application your playing out of.
And lastly check the cables and all connection's.