board

Posted on Jul 29, 2006 02:17 pm
Clansonkid
MegaMan
Member Since: Mar 05, 2003

is there a way i can patch a guitar pedal to my mixer and run a guitar track through it?

Noize2u
Czar of Midi
Administrator
Since: Apr 04, 2002

Jul 29, 2006 02:25 pm

Do you mean as in sending the allready recorded guitar track out of your sound card and back in after running through an FX pedal. I think it depends on the pedal, if it will accept a line level signal or not. You could try it running a very low level signal first and see. I know I used to run line outputs from my keyboards into stomp boxes, but that was years ago. Not sure if the newer ones can accept that signal or not.

As stated try a very low level signal first.

Clansonkid
MegaMan
Member
Since: Mar 05, 2003

Jul 29, 2006 02:56 pm

should i run through aux switches? where should i put the 1/4"'s

Noize2u
Czar of Midi
Administrator
Since: Apr 04, 2002

Jul 29, 2006 03:05 pm

Ya, I guess I didnt think about that part. If you have an aux send/return you can use that. Just bring the signal into the mixer, add the effect loop running through the aux and then send it out a buss and your all godd.