Hooking up analog equipment posted by...

Hooking up analog equipment

Posted on Jul 25, 2011 07:25 am
Dahla74
Member Since: Jul 25, 2011

Hello. Im having trouble knowing where all my analog gear should be connected and in what order if i place it in a chain.
For exampel on the insert.
I have a Behringer Mx8000 mixing console.
Today my connection on the insert is as follows:
Samson d2500, Behringer ultra-dyne 9024. After the ultra-dyne i split left and right too two separate Lexicon mx200 reverbs for the ambient reverb (the stereo signal came out mono. Thats why i use two reverbs) finally the left and right signal goes into a stereo reverb and then back to the console thru the Y-cable

Is there any better ideas on how to connect, change order or remove something on the insert so feel free to tell me..

[ Back to Top ]

dbmasters
Administrator
Since: Apr 03, 2002

Jul 25, 2011 09:30 pm

I don't understand why you have so many reverbs...youhave two mono signals going into a single stereo reverb? Why don't you take the two mono units and put them on effects loops so you can use them elsewhere easily, just take them out of the insert....

Dahla74
Member
Since: Jul 25, 2011

Jul 27, 2011 12:42 pm

As i mentioned in my first post. The first two reverbs is used as ambient reverbs and the reason i used two of those was that it otherwise crossed the signal and came out mono...but anyway that is not my main question... My question was :how i should hook it up?!?

Ive taken away everything exept the eq since the manual for the mixingconsole starts making sence. Should i keep the ultra-dyne in the chain and shall i place before or after the eq???