Jan 27, 2009 10:53 am You might want to check the manual on that one... Is "Sub Bass" an additional output? Is it a built-in digital crossover? Is it some goofy "loudness curve" for quiet listening?
set up delta1010 question
Posted on Jan 27, 2009 03:15 am
mrmorpheus711
Member Since: Jan 27, 2009
ok.. heres my set up....im going from my pc into delta1010, out of there into my ssl alpha channels, then into apogee converter, into master link,,, question is in my control panel of the delta, should the subass be on or off.. which is true? also im using a pair of JBL LSR4328P and i dont know if the sub bass in the control panel of the delta1010 should or shouldnt be on sub bass etc... which is true.... help
[ Back to Top ]
Jan 27, 2009 10:53 am You might want to check the manual on that one... Is "Sub Bass" an additional output? Is it a built-in digital crossover? Is it some goofy "loudness curve" for quiet listening?
Jan 27, 2009 10:57 am Are you using the latest driver? I think they may have pulled bass management out in the latest release.
...or, get this www.devicemanuals.com/gui...TmpjME1UWT.html
Jan 27, 2009 08:12 pm My question would be. Exactly what is it you are trying to do? I'm confused why you are running out of a Delta into a pair of expensive channel strips into another converter, and then were does the masterlink go? Are you trying to do a surround set up or?????
Jan 27, 2009 10:13 pm noize2u... thats is how the chain should go according to them at ""sweetwater" where i purchased everything...masterlink is my final destination in the chain! is is this wrong??... basic setup, recording n mixing
Jan 28, 2009 05:38 pm No, I'm just curious what it is exactly you are doing with the device chain. And were the audio is heading after the masterlink.
But no, the sub-bass should be off. That is an option if the Delta is going to be used for a surround output.
Jan 28, 2009 09:36 pm ok.. well master link is the last destination, burning cd know what i mean..i pick up that you seem to think the alpha channels into rosetta is wrong etc,,,
Jan 28, 2009 10:06 pm Oh no, not wrong at all. I was just curious why you were using the Delta outputs through the SSL into another AD/DA converter then into masterlink.
I think a bit better output then the Delta would bode well here. That was my main reason for being curious on the signal chain.
Jan 28, 2009 11:58 pm The DA and AD on the Rosetta should work independently if I recall... Been a while...
Of course, you could always go straight back into the DAW for editing (would probably serve you much better than editing in the ML. It's a nice unit, but it's clunky as hell for editing...
Feb 01, 2009 01:10 pm it is clunky! i do just that...back into DAW...I RESENTLY GOT A G BUS COMPRESSOR ( SSL) SLAMED IT,,, BOUNCED IT TO 2 INCH TAPE AND THREW IT BACK,,,,WOOOOOOW
|
Related Forum Topics: |
If you would like to participate in the forum discussions, feel free to register for your free membership.