Mbox2 and Yamaha mixer mg12/4x
Home > Home Recording Forum > Recording Techniques > Mbox2 and Yamaha mixer mg12/4x
Posted on Jan 24, 2009 02:38 pm
mrmoet
Member Since: Jan 24, 2009
Hello all..I am having problems configuring my mixer with my mbox2 and laptop. Protools starts all well and done but as soon as I create a new track I can not playback and hear the track at all. I have my mbox patched from the 1 and 2 inputs into the mixers outputs but not sure which outputs should be patched into the mixer. Would any of you pros give me the configure sequence for this system that i have here. I am inputing all my instruments into the mixer...guitar, mic, piano, bass and nothing in the mbox. Hope to hear with your recommendations...
thanks..mrmoet.
[ Back to Top ]
Noize2uCzar of MidiAdministrator
Since: Apr 04, 2002
Jan 24, 2009 09:49 pm I would suggest that if the mixer has a group or sub output you use that for sending to the 1/2 inputs of the Mbox. Then simply route the outputs of the Mbox back to say channel 11/12 of the mixer and your all set.
Then you simply assign whichever input's you want to record from the mixer to route them out the group or sub outputs.
mrmoetMember
Since: Jan 24, 2009
Jan 25, 2009 01:28 pm I did all that actually and nothing is recording. My inputs are the same prior to connecting the mbox and was using krystal and had no problems. I am not sure why I am not able to record or playback.
Noize2uCzar of MidiAdministrator
Since: Apr 04, 2002
Jan 25, 2009 07:37 pm You have the correct driver's selected in the audio options section of PT? And as well you are assigning them correctly in the track view input and output section's?