Posted on Jun 17, 2009 08:27 pm
listen68
Member Since: Jun 17, 2009
A newby here - sorry for the elementary question!
I have an unpowered mixer with a single 1/4" out for the monitor send. I have 4 floor wedges to power and a two channel amp to do it, 2 wedges chained together per side.
My question is ... how do I take a single 1/4" send from the unpowered mixer and split it so I can send it to both sides of the power amp? Is it as simple as having the right cable to do it (single male 1/4" to 2 male 1/4")? Would that cause a problematic signal level drop or potentially damage the amp? How would you do it?
When it comes to messing with my power amps, I'm hesitant to be experimental. Plus I need the gear working for gigs! I usually only run 2 wedges max.
Thanks for the help...
[ Back to Top ]
Related Forum Topics: |
If you would like to participate in the forum discussions, feel free to register for your free membership.