UCA200 Problems..
Home > Home Recording Forum > Recording Techniques > UCA200 Problems..
Posted on Aug 08, 2007 07:22 pm
JonAck14
Member Since: Aug 01, 2007
Hey guys, I've recently purchased a Behringer Xenyx 1204 mixing desk which has come with a UCA200 USB audio interface. I have a M-Audio Audiophile 192 soundcard and am attempting to record on Cubase SX3. The problem being when switching the Master ASIO driver in Cubase to the UCA200 i got an error message saying 'the ASIO driver could not be found'.
I have emailed Behringer Tech support about this and they send me a driver which ive copied into my system32 folder and is running fine, but when i try to switch the master ASIO driver to this new driver i get an error message saying 'driver could not be initialized'.
Any suggestions on what to do or why this might be happening?
Apologies for another post on this as i trust im not the first to have a problem with these USB audio interfaces.
[ Back to Top ]
Aug 09, 2007 02:02 pm i had to download asio4all, which is not the same driver that behringer advises. the driver they advise is about 3-4 years old, so if your program is newer than that, try asio4all 1st. is not the best, but is newer and fixed my (major)problems with my uca202. if that does not work, it may be that you're trying to use the uca and a pci card.....you may want to try plugging the mixer into your soundcard and saying piss on the uca. or take your soundcard out of the picture and just use the uca. hope this helps.
peace.
