Routing Question
Home > Home Recording Forum > Gear Gab > Routing Question
Posted on Nov 04, 2003 05:30 am
Loki
Cone Poker
Member Since: Apr 07, 2002
My board has a main out that is left and right, and group one and two outs. My question is I can route channels to group 1 or two and some to main left and right in order to record four simultanious tracks?
[ Back to Top ]
Nov 04, 2003 05:35 am I dunno how your board is set up (as I recall it's a phonix, with which I have no experience) but each channel strip should have little buttons to send the signal to the main bus or the group busses. After you have a couple going to main and a couple going to the groups, then, take the two going to main and pan one hard left and one hard right...then do the same to the two going to the groups, unless you see group one and two are seperately assignable...
LokiCone PokerMember
Since: Apr 07, 2002
Nov 04, 2003 07:53 am yeah each channel has a bottn to toggle it to either the main outs or group outs, and i assumed hard panning would be how to switch between channels, just didn't know if it was possible to use the group and main outs simultaniously, but I'll take that as a yes.
Nov 04, 2003 10:01 am just plug them all up to your four inputs on t he delta, pan the channels accordingly and just start messing with the buttons and faders and junk while a signal is going into ti and watch the delta control panel for peaks in each channel. you'll have it sussed out in no time
