Jun 06, 2011 08:05 pm
No, it's no that hard to do. But, you will need a crossover. The amp section of your speakers contained the crossover. Just keep that in mind.
But, all you do is buy an NL4 panel mount connector. Drill a hole in the side of you speaker to where it will lay flat. Cut the Red and the Black wires going to the woofer, and put the Red on 1+ of the NL4. And the Black on 1-. Do the same for the tweeter, but put them on 2+ and 2-.
And that is all there is to it. Just as I pointed out, you will need a crossover to run them at that point.