recording from a dynacord 600 II powermate

Posted on

Member Since: Feb 16, 2009

Hi, I'm having a problem recording from my computer via a Beringer UCA202 soundcard outputs, into my mixer back out the mixer via the record sends into the inputs on the UCA202, I just get a very low recording, I know the output on the record sends is set at -10 dBV but it really is to low to listen to, I have been told I might need a preamp to boost the volume into the UCA202.

Any ideas would be helpful.

2hat.

[ Back to Top ]


Administrator
Since: Apr 03, 2002


Feb 16, 2009 07:07 am

First welcome to HRC.

Second, might I ask why you are sending anything back out of the computer into the analog domain? Are you using the mixer for anything you couldn't do while leaving the signal digital?

Member
Since: Feb 16, 2009


Feb 16, 2009 08:45 am

Hi, I am coming from a karaoke hosting program in the computer (compuhost) into the UCA202 via USB, then out from there into the mixer stereo inputs on the mixer for the live mix. I hope this answers your question, i'm new to this.

Regards.

2hat

Member
Since: Feb 16, 2009


Feb 16, 2009 10:23 am

The reason i'm using the UCA202 is that it's a better sound than my internal soundcard.

2hat.

Czar of Midi
Administrator
Since: Apr 04, 2002


Feb 16, 2009 05:18 pm

If you are looking to use a =4dbu then you can use the main outs on the mixer which do not look to be powered.

But if you must use the RCA then yes, you are going to need a pre amp to bring the signal up to a good level.

Related Forum Topics:



If you would like to participate in the forum discussions, feel free to register for your free membership.