Beat Based Echo on DP5???
Home > Home Recording Forum > Gear Gab > Beat Based Echo on DP5???
Posted on Aug 20, 2008 03:56 pm
Indellable
Music Afficionado
Member Since: Aug 12, 2008
I know the echo settings allow you to set them to be beat based, but is there a way to switch the BPM setting on DP5 after you have already recorded? For example, if I open a new session and record several tracks at about 95 BPM - the default BPM is set to 140. If I echo a vocal I recorded to 1/4 beat based it will obviously echo way too fast because it is going off that 140 mark. If I try to chnage the 140 to 95 it manipulates the entire recording. Any way to change the BPM up at the top after you have already recorded? Thanks!
[ Back to Top ]
Noize2uCzar of MidiAdministrator
Since: Apr 04, 2002
Aug 20, 2008 09:31 pm You have to set the project's BPM before you start the recording to 95 or whatever you need. Then the entire project will stay at 95.
If you change the project BPM it will of course change the BPM for the entire project.
I would imagine though that if you only want certain section's at 95 and others at 140 you should be able to do that. I know I can in Sonar or Project 5 without any trouble at all.
