SEQUEL - how to select new Sound card driver
Home > Home Recording Forum > Computers & Software > SEQUEL - how to select new Sound card driver
Posted on Dec 03, 2007 10:52 am
Kugerand
Member Since: Nov 27, 2007
I have been using REAPER which has several options to select driver for sound card. SEQUEL has the same but only one driver shows up in the list.
Problem I have is FULL DUPLEX DRIVER gives latency errors, where the WAVE driver does not. I verified this using REPEAR.
If I can get the Sequel to select WAVE driver, it might solve the issue.
Any suggestions would be appreciated.
[ Back to Top ]
pjkPrince CZAR-mingMember
Since: Apr 08, 2004
Dec 03, 2007 02:30 pm I think it will depend on what soundcard you have (which you didn't list).
Try ASIO4ALL, maybe you can get SEQUEL to pick that up as an interface driver.
List the equipment you're using will help us greatly, to help you.
Or better yet, list in your profile what you're using, like I have in my profile.
Noize2uCzar of MidiAdministrator
Since: Apr 04, 2002
Dec 03, 2007 05:47 pm Yep, knowing what you are using for a sound card will help us figure things out much easier.
Dec 04, 2007 10:37 am Sorry - I am using a Creative Labs Sound Blaster 24 bit
Noize2uCzar of MidiAdministrator
Since: Apr 04, 2002
Dec 05, 2007 03:37 pm Oh ya, then you should actually be using the WDM driver that Creative supplies. And as well that will work with the ASIO4ALL Set up as ASIO4ALL uses the WDM drivers as its base for operating.
