Jan 05, 2007 11:16 pm Welcome to HRC.
Try going here and download and install these drivers. I know it is supposed to be plug and play, but many times the devices simply will not do the plug and play option.
Behringer UCA202 U-Control
Posted on Jan 05, 2007 01:21 pm
RadioJimmydreamz
Member Since: Jan 05, 2007
Has anyone had much luck with this? I have one I want to use with my laptop. The laptop see the unit, but when I select it as the primary audio device, I can not access any recording features at all.
When I bring up the "mixer" from the toolbar, there is no slider for line-in, and I can not click on Propertys and add it, it's not available from the list.
When I try to switch the "mixer" from playback to record, there are no sliders available at all.
Any help would be greatly appreciated.
[ Back to Top ]
Jan 05, 2007 11:16 pm Welcome to HRC.
Try going here and download and install these drivers. I know it is supposed to be plug and play, but many times the devices simply will not do the plug and play option.
Jan 06, 2007 12:07 am Thanks for the welcome Noize!
It's late, so maybe I'm missing something, but I don't see the "here" or drivers your talking about?
Jan 06, 2007 01:02 am Oops, I forgot to add the link.
www.behringer.com/05_supp...ds.cfm?lang=eng
Its right at the top.
May 02, 2007 02:04 pm I just got a xenyx1832fx, i connected the uca200 rcs input to the sub out at the rear since my unit does not have the alt3/4. i had the uca200 rca out connected to the rca cd input of the mixer. i placed the microphone at channel 1 & 2. routed it to the sub(press sub) and increased the level of the main sub fader to about 7 or 8. I had the main level at about 7 & 8 with the trim at about7. I opened the sonar prod. edition and configured the input audio by clicking OPTION set at audio codec and my output set at soundblaster1.5 since this is my soundcard.opened a test project from sonar and talked through the mic & I got a signal from the meter. I adjusted it to an audible level and I also got a wave signal of my voice on track 1, hope this can help. regards to all!!
May 02, 2007 02:12 pm by the way, you also have to click OPTION and choose WDM from three choice since UCA200 is WDM.use an adapter from rca to a 1/4 unbalanced mono to connect at the subout at the back of the mixer.
May 02, 2007 02:37 pm for your regular playback of your cpu go to start open the sound and choose the soundcard you're using click on it, in my case, i clicked on the soundblaster 5.1, this is separate from the sequencer configuration setting where we are using uca200 soundcard w/c comes with the xenyx so you need not change setting everytime.
|
Related Forum Topics: |
If you would like to participate in the forum discussions, feel free to register for your free membership.