Dec 27, 2006 08:38 pm That's kinda vague, i'm not sure that path you have there.
from guitar, to amp, that i can figure out.
from amp to mixer, how are you doing this? are you putting a microphone infront of the speaker? are you running from the line out on an amp? are you coming out of the fx send?
basically, what kind of amp, and what exactly are the connections.
The LED level meter, i'm assuming is the master led tree, on the right.
If there's nothing there, then first I'd check the gain, or trim at the top of the channel you're plugging into. Plus, are you plugging the guitar cord into the line input, and not the insert jack. Insert is used for something else.
If you're using a mic, are you using a condensor mic of some sort, they will need phantom power, enables via the phantom button on the right.
I guess if that doesn't work, then start at the beginning, ensuring there's signal at each step: guitar, cord, amp (i'm assuming there's sound coming from the amp) then is there a signal coming out the amp (however you've done it). If there is, then it should show up at the head amp (preamp) of the mixer. Turning up the gain should make the clip light flash, meaning there's signal.
HTH, good luck.
